![]() ![]() To ensure that the outputs for turnouts or signals are always used inverted, the value in the field "Parameter" on the "Interface" tab of these objects must be set to "1". Rocrail habilita el control manual de los trenes, un modo automático, y una combinación entre ambos. Check the integrity of all locomotive addresses and that Elite still works the layout in Standard and Classic Modes after any update. La página oficial de Rocrail menciona a los sistemas en los vagones, luces ambientales, clima y simulación de horarios. only in the terminals and two turnouts per mainline station to allow CTC line-up for meets and passes, occupancy detection on the mainline So if Koploper can handle that without me having to take a major course in device. It is advised to download the latest update (currently v 1.44) and instructions from Hornby web-site and install on the Elite. The layout is quite simple point to point operation, all trains under manual control, minimal electrified turnouts i.e. When changing the option "Invert / Pull-up", the following must also be observed: For outputs, the "Invert" setting here is only valid when starting Rocrail. The Elite must have at least firmware vers.1.2 installed (check for this at Elite start up). After that, all used pins are listed at "Query" and the options can be changed directly. a verificare come sono state generate le routes. Check out the other support options below. Then Rocrail should be restarted and all commands of objects that use output pins should be executed once because at startup all used input pins and, when executing a command, all output pins are created from Rocrail in the DCC++ CS temporarily. Le loco funzionano anche bene da blocco a blocco per dopo che ho creato le pianificazioni certe loco. Best Way to Get Help Unfortunately, this project hasnt indicated the best way to get help. ![]() It is generally recommended that you first create all objects in the plan with the desired pins. Manual intervention is required, only in the case that other options than the default ones are to be used at startup. For input pins, the option "Invert / Pull-up" is activated by default, i.e. Rocrail automatically defines Arduino pins as input or output pins as soon as the pins of such a DCC++ CS are used for triggering sensors, turnouts or signals. Usually no manual settings are required here. 1 = use internal pull-up resistor for the pinĠ = don't use internal pull-up resistor for the pin ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |